mnottertail
Posts: 60698
Joined: 11/3/2004
Status: offline
|
Yes the first link is like one I have seen, but this one is a box core, and not the H beam I saw and that has absolutely been torch or plasma cut and not thermite cut, here is why; if we examine the dross (that is that grey looking stuff to anyone who looks at this picture). If we look at it in map directions note the rusty edges at the nnw and ssw corners, that is wet moisture rust, that has been cracked awhile. No dross near it either. Hard to say cause of the shadow but I see no irregularity on the west side, indicating to me that it was cut from the outside (west) towards the inside to the (east) note the curve under the upper (nnw) and continuing onto but not into the lower rusty part (ssw)... that angle is about 50-60 degrees downward as is the other side, on about the same plane, if I have aught for perspective. The red circle-- this is where I think a beginning blowhole was made just to the west is another one and looking at the dross the guy running the hatchet came from the north around to the east and looking at the nne corner he built up dross coming around the corner plugged the spray hole with dross and had to start again...Now your blue circled area.....we see the dross on the outside, once again supporting my opinion that he started either on the west side where the cracks were or the north side (more likely) and then the east side or part of it, did the west side (all the while whatever was cut off was being held in the air by a crane and tipped towards us. and that is why the south cut is not level on its plane and dwindles toward the ssw corner since I see the cutter propped with one hand behind the north side and stretching in to cut the inside facing us, using the torch in his right hand (in all other cases he could use both hands and draw the hatchet towards him.....extend your left hand onto a door jamb and lean at about a 30 degree angle on it so that your right hand is in an open doorway, if you have a rather heavy rolling pin, or a typical 9 inch cast iron pan hold it in your right hand and draw an imaginary line horizontally in the air (swinging your wrist), you will readily see that you want to drop it as you travel from left to right in your vision. I would have expected to see at least baseball sized globs of dross (with alot of pencil sized or larger visible holes in it if it was thermited, since thermite creates oxygen.........nope, that was cut with the presence of a lot of noble gas.......not consistant with thermite reaction......either trust me or google this all out, but I believe you have run a gas hatchet havent you? You then know this to be true, whether they used acetylene or plasma (argon/acetylene/oxygen) that beam that is round............uh uh, that aint no beam, it was built that way at its installation.note the inner and outer lip at the top no sign of inner or outer lip on the bottom, note also that it it has a top slope , but the inner and outer circumfrences are perpendicular to each other and the structure.........fucker was built that way or the inner and outer edges would have went somewhat along the lines of the slope. I would like to report that on both sides of the flap of metal in the foreground (I don't have a clue what the fuck that is) it can clearly be seen that it has been ground. How come? Who the fuck knows, but it don't look dastardly to me............
maybe more later.
Ron
< Message edited by mnottertail -- 10/31/2006 7:12:52 PM >
_____________________________
Have they not divided the prey; to every man a damsel or two? Judges 5:30
|
RE: 911 - Al-Qaeda or Hoax? - 
Profile
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread