advice needed re cb3000 (Full Version)

All Forums >> [Community Discussions] >> Ask a Mistress



Message


canupleaseme -> advice needed re cb3000 (12/27/2006 3:44:58 AM)

Hi everyone[:)]
i am looking for some advice with regards to the cb3000.  Could anyone tell me if its normal for it to put pressure on the testicals ? i know they are meant to make it uncomfortable and difficult hence they are chastity belts but we have found that when it is on properly that the pain it is causing this area makes it too much to wear and whilst i want my man locked up i dont want to contsantly make his balls sore.
Any help would be most appreciated. 




jeffman1234 -> RE: advice needed re cb3000 (12/27/2006 5:06:50 AM)

You need to use the size ring that is not too small but just small enough so it does not come off.




canupleaseme -> RE: advice needed re cb3000 (12/27/2006 5:08:58 AM)

[:)] yeah we have tried that one, i reakon he will just have to get used to it [:D] lol did you find the same with it ?




Miss_Kittie22 -> RE: advice needed re cb3000 (12/28/2006 11:26:45 AM)

 I found that if you leave just a bit more room between the ring and the front part it doesn't apply as much pressure...just use a longer peg and a different spacer. The problem we had with ours though, was some serious and painful swelling of the testicles and penis...so beware of that. We're not sure what caused it, but after a few hours of being out of the device it went down and things returned to normal. Good luck and I hope everything works out well, chastity is such a wonderful toy!

*~Kittie~*




canupleaseme -> RE: advice needed re cb3000 (12/28/2006 1:27:50 PM)

Kittie
Thankyou so much for your advice [:D] its something i really want to work but i dont want those kind of effects so we will give that a try !! And your right chastity is certainly a fun toy [:D]




chasteslave -> RE: advice needed re cb3000 (12/28/2006 6:34:50 PM)

Maybe if you try a bigger ring, you might try adding the points of intrigue or the ksd or ksd2 devise, so it will add a little more security. That way with the bigger ring, it might not put as much pressure, but you have "piece of mind" with the other items for security.




tieyou -> RE: advice needed re cb3000 (12/28/2006 6:43:10 PM)

I want one of these for myself.  I want to go without sex for a month to see what effects is has on my orgasm.  I've been told my errect penis is very big.  But its only 8 inches.  I know its above average but some women are scared to take it inside them.  Would I need a 'large' device?  It's about 5 inches flacid.  My balls are quite tight aswell.  Then again, maybe thats because of all the sex I have.  Could someone suggest what size I need.




herpet1313 -> RE: advice needed re cb3000 (12/28/2006 8:18:47 PM)

It also helps if your man is shaved smooth. The device does take some getting used to and i found that a little baby oil helps immensely on any and all spots that get irritated.




draba -> RE: advice needed re cb3000 (12/28/2006 9:02:28 PM)

Try not using any spacers. I found this works best for me. With the right size ring and no spacers there is plenty of room, but can not slip off. Sounds like you are pinching the balls. It should not hurt, just keep one chaste.




ObedientYYC -> RE: advice needed re cb3000 (1/4/2007 2:42:41 PM)

The cb3000 (and probably most male chastity devices) requires a lot of playing with to get comfortable, because it has to fit extremely snugly yet also comfortably (unless an erection is attempted..lol).     Just play around with all the different rings and spacers, and you should be able to arrive at a configuration that works well for you.   Some degree of customization may also be required (for example, you may have to cover the top-vents with a piece of packing tape if they cause irritation).   If a guy is really well hung, then "The Curve" may be better bet than the cb3000, as the tube part is larger.

Also, the device really is not secure without a KSD (extra cock-ring attachment), and fitting this properly requires even more careful attention, and the use of sandpaper to customize its very-tight fit.    Best of luck with it!




feralcat -> RE: advice needed re cb3000 (1/4/2007 9:28:47 PM)

hmmmm..perhaps his sack is too tight. Try having him stretch the ball sack a bit so they hang a bit lower...stretching can be done with a parachute or wrapping the sack just above the balls with a thinner cord.It pushes the balls lower and stretches the skin.Should make wearing the cb a bit more comfortable.Then again comfort is all in the little head !


good luck....Ms Feral




looking4phun -> RE: advice needed re cb3000 (7/17/2007 10:15:04 PM)

TO TIEYOU,
 
You will never fit into a CB3000. I think about 5 inches is the max for it, maybe 6. You need the "curve" or more, which has a bigger cock cage.




onthenosetone -> RE: advice needed re cb3000 (7/17/2007 10:48:25 PM)

looking4phun
is right, i'm above average too and don't fit into the 3000, we gave up with the whole CB range in the end and invested in a steel belt.....

If we'd done that in the first place all the money we wasted on "off the shelf chastity devices" over the years would have paid for the steel belt 3 times over.....

If your just looking for chastity play then i guess plastic stuff is ok, but for long term chastity steel custom made is really the only way to go, expensive but well worth it.....




Page: [1]

Valid CSS!




Collarchat.com © 2025
Terms of Service Privacy Policy Spam Policy
0.03125