LadyPact
Posts: 32566
Status: offline
|
That picture can be duplicated without anything being inserted into the urethra. Step 1 - Prepare wick - Do this the same way that you would if you were preparing the wick to pour a candle into a mold. Curl about a quarter of an inch of the wick underneath a piece of mold sealer. (Again, the same as you would use if you were pouring wax into a mold.) Step 2 - Cover the opening - Mold sealer is just tacky enough to stick to skin when it has been flattened to between an eighth and a sixteen of an inch thick. Place the flattened mold sealer over the hole, with the curled end of the wick toward the penis, and the longer end of the wick that you intend to light going away from the penis. Step 3 - Start dripping wax - Unlike pouring melted wax into a mold, you are actually going to do the sides first and as your wax hardens, move further towards the wick. Depending on how long you intend to 'burn your candle' is how thick you want your wax to be. Drip wax from the base of the penis toward the head and back again until you have a smooth, clean look. Step 4 - Apply as many coats of wax as desired, allowing each coat to cool and set before applying the next. (The idea is to not remelt the wax you have already applied.) The shape will hold for several coats. Take a great amount of care that the wax covering the mold sealer/wick area is at least a half an inch thick. Step 5 - Finished photo shoot product. Light your wick and even let it get to the point where some of the wax will drip from the end of your 'candle'. Get your pictures fairly quick because you do not want the flame to reach the mold sealer. That stuff certainly will conduct heat if the flame gets close enough. Tada!
_____________________________
The crowned Diva of Destruction. ~ ExT Beach Ball Sized Lady Nuts. ~ TWD Happily dating a new submissive. It's official. I've named him engie. Please do not send me email here. Unless I know you, I will delete the email unread
|